Roberts Gorden MGB Series Wartungshandbuch PDF herunterladen (Seite 21)

SECTION 5: HEATER INSTALLATION

15 of 85

SECTION 5: HEATER INSTALLATION

5.1 General

Heaters are designed for floor standing vertical

installation. Special versions supplied with steel

channels to support the heater are available and

may be mounted horizontally. When installed

horizontally, the heater will normally lie on its left

side when viewed from the burner. The heater

should be placed on a firm, level, non-combustible

surface that can support its weight. See Page 8,

Section 4.1 for weight details.

5.2 Handling

All cabinet heaters are supplied with an integral

pallet and shrink wrapped. Remove pallet before

installing the heater.

Figure 3: Typical Installation of an Gas-Fired Cabinet Heater

*100 mm (4") and 150 mm (6") flue use stainless steel or aluminium flue pipe.

** 229 (9") mm flue use stainless steel single wall flue pipe only.

Crush Hazard

Use proper lifting

equipment and

practices.

Falling Hazard

Use proper safety

equipment and prac-

tices to avoid falling.

Severe Injury Hazard

Use proper lifting

practices and equip-

ment.

Equipment and

accessories are

heavy.

Cut/Pinch Hazard

Wear protective gear

during installation,

operation and

service.

Edges are sharp.

WARNING

Failure to follow these instructions can result in death, injury or property damage.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 91 92

Keine Kommentare

Roberts Gorden MGB Series Wartungshandbuch Seite 21