Roberts Gorden MGB Series Wartungshandbuch PDF herunterladen (Seite 60)

COMBAT

CABINET HEATERS INSTALLATION, COMMISSIONING, OPERATION AND SERVICE MANUAL

54 of 85

Direct-Spark Igniter Replace if there are cracked ceramics, excessive carbon residue, or erosion

of the electrode.

See burner manufacturer’s instructions.

Thermostat There should be no exposed wire or damage to the device or wiring.

See Page 27, Section 9.

Support Points Make sure the heater is properly supported.

Make sure the heater is placed on a firm, level, non-combustible surface that

can support its weight. See Page 8, Section 4.1.

Silicone Tubing Ensure tight, secure fit on all pressure fittings at pressure switch,

burner partition, and blower outlet.

Gas Valve Verify that cap covering pressure regulator adjustment screw is secure and

has not been tampered with.

Verify all wiring connections.

Condensate Drain

(when installed)

Flush drain and clear any obstructions.

Ductwork Consult an indoor air quality professional for proper cleaning procedures

Air Circulation Blower For a complete inspection, refer the manufacturers Installation, Operation and

Service manual.

Wall Plate If wall plate is present, make sure it is legible and accurate. Please contact

Roberts-Gordon Europe Limited if you need a wall tag. See Page 4, Section

2.1.

Safety Labels Product safety signs or labels should be replaced by the product user when

they are no longer legible. Please contact Roberts-Gordon Europe Limited or

your ROBERTS GORDON

independent distributor to obtain replacement

signs or labels. See Page 3, Figure 1.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

Keine Kommentare

Roberts Gorden MGB Series Wartungshandbuch Seite 60